Conductive caster resistance ranges and acceptance: how to test ESD casters

Industry News admin

ESD casters are judged by one number: wheel-tread-to-bracket resistance. Conductive, static-dissipative and insulating ranges explained, with measurement pitfalls, grounding-chain checks and an acceptance checklist.

Short answer: whether an ESD caster passes comes down to one measurement - resistance from the wheel tread to the metal bracket. Industry practice sorts casters into three bands: conductive (roughly 10⁴-10⁶ Ω, fastest charge bleed-off), static-dissipative (roughly 10⁶-10⁹ Ω, gentler discharge, often preferred), and ordinary insulating wheels (above 10⁹ Ω, no ESD capability). For a given project the acceptance band follows the purchase technical agreement and the equipment maker's ESD program - industries differ.

How to measure

A resistance meter gives a usable field reading: 1) clean and dry the tread (dust and moisture films lower readings and fake a pass); 2) one lead on the tread (conductive sponge or wetted electrode), the other on the metal bracket or mounting hole; 3) measure at several points across the tread and across several wheels, and judge on the worst reading. Resistance drifts with humidity - readings run higher in dry air, so the acceptance condition should resemble the actual service environment.

Do not skip the grounding chain

A conductive wheel is only the first link: charge must travel tread → bracket → equipment frame → earth, and one broken link voids the chain. Common breaks: insulating pads between bracket and frame, paint on the mounting hole, or an ungrounded machine. Measure the whole chain once - tread to frame to ground terminal - it reflects the field truth better than the wheel alone.

Selection and acceptance checklist

1) fix the band (conductive vs dissipative) from the equipment ESD program and require batch resistance reports; 2) run the normal caster flow for load and tread - conductive series such as the XD series must pass both load and resistance tables; 3) write the measurement points and acceptance band into the PO so "anti-static" has a numeric definition; 4) sample-test each incoming batch. Resistance ratings and load data for the DARCOR conductive range ship with the product documents - defer to the original manuals.

Send the target resistance band and load conditions to Juanmu to cross-check caster selection against your ESD program.

Request a quote for products in this article
Contact Us Contact Us
Back to top