Thermal design for EV control cabinets: the heat path from chip to enclosure
Cabinet cooling is a four-stage heat path: chip, interface material, heatsink, cabinet air - and the contact resistances stack. Stage-by-stage selection pointers and the enclosure-level trade-off between ingress protection and cooling.
Short answer: electronics-cabinet cooling is a chain heat path - power chip, thermal interface material, heatsink/cold plate, cabinet air, ambient - and the total resistance is the sum of every stage. If any single stage is wrong, nothing else compensates. EV control cabinets (motor controllers, BMS/PCS power units) push high power density through fluctuating charge/discharge duty, so every stage deserves a line-by-line check.
Stage 1: chip to interface material
The microscopic gap between power modules (IGBT/SiC) and the heatsink is filled by the thermal interface material, and its contact resistance is the most underestimated stage - under-pressuring, ageing and wrong thickness all make it the bottleneck. Three selection pointers: thermal conductivity is only a reference, real resistance depends on the compressed state under pressure; large-area modules call for tear and compression robustness first; fluctuating duty cycles demand reliability data (thermal-resistance drift after ageing) - per the original manufacturer data. For the gap-filling stage consider silicone pads such as AGE08020, and compare compression and reliability data of thick/large-area grades like AGK15051.
Stage 2: heatsink and airflow
Fin density and duct direction set convection efficiency: fins too tight clog fast in dusty sites, and short-circuited airflow (inlet recirculating straight to outlet) spins the fan for nothing. Engineering pointers: keep the duct direction consistent with the heat-source layout (nothing hot downstream of the exhaust); choose fin pitch for site dust conditions; size fan flow from heat to be removed divided by allowable temperature rise - not from the nameplate rating.
Stage 3: cabinet and environment
The enclosure-level choice follows ingress protection: where openings are acceptable, filtered fan units are cheap and effective but depend on site air quality; cabinets requiring IP5x or better use internal/external isolation heat exchangers or air-conditioning units - trading cooling capacity for protection, sized on the allowable cabinet temperature difference. For sealed passively-cooled cabinets, move heat to the cabinet walls by layout: conduction plates bonded to hot components are an interface problem again, the same logic as stage 1.
Send the cabinet heat-source list, allowable temperature rise and site conditions to Juanmu for a stage-by-stage selection review.