Servo drive gain tuning basics: the last link of the stiffness chain

Industry News admin

Mechanical selection sets the stiffness ceiling; drive tuning decides how close the servo gets to it. A beginner walkthrough of the three loops and four tuning steps: start low, read the following error, approach critical, back off.

Short answer: the stiffness of a motion axis is a chain - ballscrew, coupling, belt, servo drive - and the softest link decides the whole. Once the mechanical design is done, the stiffness ceiling is locked; gain tuning is how you bring the electrical link up to what the mechanics allow. Poor tuning shows up as long settling tails, overshoot or low-frequency jitter on otherwise excellent mechanics.

Know the three loops first

Inside the drive are three nested loops: the current loop (factory-tuned, usually left alone), the velocity loop (the main stiffness knob), and the position loop (how tightly the axis follows). Most "rigidity" tuning happens on velocity and position gains: higher gain means stiffer response and smaller following error - and closer proximity to oscillation.

Four beginner steps

1) Start low: confirm the motor holds without buzzing or hunting on default parameters; 2) excite: use the drive's step or sine test to view the following-error trace; 3) approach critical: raise the velocity gain step by step - audible whine or position jitter marks the critical point; 4) back off: settle 20-30% below critical as the working point, leaving margin for load changes and temperature drift. Modern drives ship with auto-tuning assistants (ELMO drives include a tuning wizard), but auto results are a safe starting point - fine compensation for your mechanics still needs the manual review above, per the original manufacturer manuals.

Inertia ratio before gain

How far gain can go depends largely on the load-to-rotor inertia ratio: the larger the ratio, the sooner the same gain oscillates and the lower the usable stiffness. Estimate the ratio before tuning; if it is out of range, change the gear ratio or load structure first instead of forcing gain - the stiffness chain in action: what the mechanics withhold, the drive cannot add. Allowable ratios vary by drive series - defer to the original manuals of the Platinum Whistle and Platinum Bell classes.

Send your load parameters and target cycle time to Juanmu for an inertia-ratio estimate and a tuning starting point.

Request a quote for products in this article
Contact Us Contact Us
Back to top