Drive frequency and droplet consistency in ultrasonic nebulizers: two frequencies, do not confuse them
In ultrasonic nebulizers the piezo frequency sets the nominal droplet size, while the speed stability of the drive motor decides droplet-consistency drift. This guide separates the two frequencies and lists three supply-side measures plus motor sizing pointers.
Short answer: ultrasonic nebulizers involve two "frequencies" that are often confused - the piezo element's ultrasonic driving frequency (commonly in the 1.7-2.4 MHz range) sets the nominal median droplet size, while the speed stability of the drive motor (supply pump, transmission) decides how consistent the actual droplet distribution stays over time. Separate the two before comparing numbers.
Piezo frequency sets the nominal droplet size
In micropore / ultrasonic atomization the median droplet size is mainly fixed by the piezo driving frequency and the mesh pore size: higher frequency and finer pores give a smaller nominal median. This is locked in by the nebulizer-head design; equipment integrators choose the head against the target droplet distribution, per the original manufacturer data.
What the motor-side "frequency" affects
Supply-side pulsation is the common source of droplet-distribution drift. Peristaltic or piston pumps are driven by stepper motors; visible speed fluctuation (low-frequency oscillation, lost steps, start-stop shocks) makes the liquid film on the mesh vary periodically, and the emitted droplet distribution drifts with it - seen as unstable nebulization rate and a widening distribution. Three supply-side measures: 1) use microstepping to suppress low-frequency oscillation; 2) avoid frequent start-stop during nebulization, prefer continuous steady feeding over pulsed dosing; 3) keep the supply line short and fixed to limit pulsation amplification.
Sizing pointers
For small-flow medical/detection nebulization (supply in the 0.5-5 mL/min range), a small stepper such as the FL35ST with a microstepping drive usually provides steady feeding; for larger flow or higher supply pressure, look at the FL42STH class - verify torque and speed margin against the pump load curve, per the original manufacturer data. The FULLING series offers multiple sizes.
To match a nebulizer head with its supply drive, or to have Juanmu size it against your target droplet distribution, get in touch for support.