What is arcmin: a plain-language guide to gearbox precision ratings
Arcmin is the standard precision unit in gearbox datasheets: 1 degree = 60 arcmin, and the rating describes output-shaft lost motion on reversal. This guide explains what arcmin means, how it is measured, and how to convert it into end-point deviation for sizing.
Short answer: arcmin (arcminute) is a unit of angle, 1° = 60 arcmin. In a gearbox datasheet the arcmin rating usually describes the lost motion (backlash) at the output shaft when reversing under rated load - the smaller the value, the more accurate the reversed positioning. Like gear ratio and rated torque, it is a hard specification to check line by line during sizing.
Why arcmin instead of degrees
Precision gearbox backlash is typically a few arcmin or less; expressing that in degrees yields awkward decimals (0.05° is far less readable), so arcmin is the natural scale: 3 arcmin = 0.05°, 1 arcmin ≈ 0.017°. Also check whether the datasheet uses arcmin or arcsec (1 arcmin = 60 arcsec) - mixing up datasheets from different makers is where this most often goes wrong.
Reading the arcmin rating
Three points: 1) the rating is normally "≤ x arcmin" - an upper limit for that size, not a typical value; 2) it is measured at rated torque on reversal - backlash measured at light or no load will read smaller and cannot be used directly; 3) within one series, different sizes carry different arcmin classes - stiffer, more compact designs control backlash better and cost more. The ZHENKANG ZKRV-E series lists the arcmin class of every size in its catalogue; confirm against the target size before sizing, per the original manufacturer data.
Converting to end-point deviation
What sizing actually cares about is how much deviation arcmin creates at the end of the mechanism. The conversion: end-point deviation ≈ arm length × arcmin × 0.00029 (the sine of 1 arcmin is about 2.9×10⁻⁴). For a 500 mm arm with 3 arcmin backlash, the end-point error on reversal is roughly 0.44 mm; at 1 arcmin it is about 0.15 mm. Conversely, divide the positioning tolerance your process allows by the arm length and by 0.00029 to get the maximum acceptable arcmin - a practical way to work backwards from process requirements to a precision class.
Read it together with torsional stiffness
The arcmin rating describes lost motion on reversal, not deflection under load. Where load fluctuates (variable-payload handling, frequent start/stop rotation), also check the angular deflection under load against the torsional stiffness; the two requirements often trade off against each other and must be balanced for the duty. Sample documents for sizes such as ZKRV-E 5E and ZKRV-E 40E can be downloaded from their pages for line-by-line comparison.
To work backwards from a positioning tolerance to an arcmin class, or to have Juanmu run the numbers for your duty, get in touch for sizing support.